Welcome to the #1 Electrical Store!
Your Dedicated Partner!
The Best Luminaire Disconnect Pricing!
EzGuard: EZ ELECTRICAL SYSTEM SOLUTIONS, LLC
The EzGuard nail plate provides complete 360° protection for electrical wiring and PEX/PE-RT water lines (3/8" and 1/2" diameter) — something a traditional flat nail plate can't do. Because it's a cylindrical steel sleeve rather than a flat guard, there's no gap for a nail or screw to slip past at an angle. It hits steel, not your wire or plumbing, no matter what direction it's driven from.
Installs into a standard 1⅛" stud hole (we recommend a hole saw over a spade bit for a clean fit), and the plastic end caps let wire pull through smoothly without nicking or scraping — a common cause of arc-fault failures down the line.
Meets NFPA 70 Section 300.4(A) national electrical code requirements for physical protection of cables and raceways.
Doing a repair or small remodel? Grab a 1-pack or 5-pack for the studs you're working on.
Framing, rough-in, or a full remodel? NEC 300.4(A)(1) requires nail plate protection whenever a bored hole doesn't maintain 1¼" of clearance from the stud edge. Since interior walls get drywall on both faces, in practice this means most standard framing runs end up needing protection on both sides of the stud — two flat plates per penetration. EzGuard's 360° sleeve satisfies that same clearance requirement in a single piece, covering both faces of the stud at once. Half the parts, half the install steps, same code compliance.
Contractor, electrician, or distributor? - We have volume pricing!
Why it matters
Arc-fault fires from punctured wiring are one of the most common — and most preventable — causes of post-construction electrical failures. A single missed nail plate on a job can mean a catastrophe for the homeowmer. EzGuard removes the guesswork: because it wraps the full circumference of the hole, there's no "blind spot" the way there is with flat plates that only protect one face of the stud.
The math that matters for bid pricing: NEC 300.4(A)(1) requires nail plate protection whenever the required 1¼" clearance from the stud edge can't be maintained — and since interior walls carry drywall on both faces, standard framing commonly needs protection on both sides, meaning two flat plates per penetration. EzGuard satisfies that same clearance requirement in one piece by covering both faces at once. That's half the part count and half the install time per penetration compared to flat plates, which adds up fast across a framing package.
Installation tip
Use a 1⅛" hole saw rather than a spade bit for the cleanest fit and easiest wire pull.
25pk Bulk Case Pricing
Buy 2-3 for: $18.49 each
Buy 4-6 for: $17.99 each
Buy 7-13 for: $17.49 each
Buy 14-20 for: $16.99 each
Buy 21 or more for: $16.49 each
The EzGuard nail plate is often compared to Southwire's SmartShield, but where EzGuard has the advantage is coverage: it protects the full 360° of the hole, while its plastic end sleeve lets wire pull through cleanly without nicking or damaging the wire jacket — something flat nail guards and stud protectors can't match.